redoing a lyman great plains rifle stock

Disassemble the black powder revolver according to its manufacturer's instructions.

Check for any left over black powder residue, which will appear as a black or gray powder. Remove all the ammunition from the gun and visually inspect the chamber and magazine to make sure it's empty. Pyrodex pellets are not recommended with Lyman side hammer guns due to difficult ignition.Ĭontinue reading here: Sight Adjustment Lyman Muzzleloaders Note: Equivalent loads of Pyrodex RS, Select, or P are acceptable. The following loads are maximum combinations of propellant and projectile for Lyman Black Powder guns. cleaning brush and/or a slotted tip cleaning rod to reach into this area. Note: The powder channel inside the breech plug is smaller than the bore diameter and does not allow the cleaning jag to enter. Inspect for the next few days just to be safe. A silicone gun rag is excellent for treating the exterior of the muzzleloader.Ĥ. Apply oil to all metal parts and reassemble. The jag screws into the end of the ramrod and will securely hold cleaning patches. All guns are supplied with a cleaning jag of the proper size.

Using plenty of clean patches, wipe the bore dry. Scrub the bore with brass brush and lots of patches. Solvents designed specifically for black powder guns are now on the market and the old standbys may be used as well.ġ. MODERN SOLVENTS-Just as effective as soapy water if properly done. A silicone gun rag is excellent for treating the exterior of the muzzleloader.ĥ. Apply a good coat of oil or moisture-displacing lubricant to all metal parts and reassemble. This not only removes the soap but also heats the steel which helps in the drying process.Ĥ. Flush the barrel with the hottest clean water available.

Wipe all powder fouling from other metal parts.Ģ. Scrub the bore with a strong solution of hot soapy water. TWO CLEANING TECHNIQUES: HOT SOAPY WATER-The traditional way to clean a muzzleloader.ġ. Of course, these Lyman guns can be cleaned without any disassembly but care should be taken to prevent water and solvents from entering the stock or lock mechanism. The hooked breech will slip right out of the tang unit with no further disassembly needed. The Lyman Great Plains Rifle, Trade Rifle, Deerstalker or Plains Pistol may be easily disassembled for cleaning by removing the ramrod, driving out the barrel wedge in the forearm, drawing the hammer to full cock and lifting the barrel (muzzle first) out of stock. You must clean your rifle or pistol after each shooting session to prevent rust and corrosion from damaging the metal parts.

Redoing a lyman great plains rifle stock